Annoy Tools Cnc Board Manual Pdf |link| Review

Match the Enable (EN) pin on the driver with the EN pin on the board.

Invert the mask in GRBL settings ($3=n) or flip the motor plug 180 degrees. 📜 Safety & Maintenance

Turn on logic (USB) before applying high-voltage motor power. annoy tools cnc board manual pdf

The is a popular choice for DIY enthusiasts building small-scale engraving and milling machines. This manual provides a comprehensive guide to setting up and troubleshooting your board. 🛠️ Board Overview

Check wire continuity or increase current via the driver potentiometer. Match the Enable (EN) pin on the driver

The board relies on , an open-source high-performance G-code parser. 1. Flashing GRBL Download the GRBL source code. Open the Arduino IDE. Flash the grblUpload sketch to your Arduino. 2. Configuration Settings

Always use a fan; stepper drivers overheat quickly. The is a popular choice for DIY enthusiasts

Always wire a physical emergency stop button to the "Abort" pins.

Proper hardware setup is critical to prevent "magic smoke" (short-circuiting).

Place jumpers under the driver seats to set Microstepping (usually all 3 jumpers for 1/16 step).