Autodata 345 The Hardware: Information Does Not Match With Your Dongle //top\\ Free

Right-click GetUID.exe (or GetUID-x64 ) and select . A unique 8-digit code will be displayed. Copy this code. 3. Update the License Registry

: In some cases, non-US regional formats can cause internal licensing mismatches. How to Fix the Hardware Information Mismatch 1. Enable Windows Test Mode

Restart the or the Start Emulator tool found in your installation directory to refresh the virtual driver. 4. Adjust Regional Settings Right-click GetUID

Navigate to your Autodata installation folder (usually C:\ADCDA2\ ).

The error "Autodata 3.45: The hardware information does not match with your dongle" typically occurs because the software's Sentinel security emulator cannot verify the unique hardware ID (HWID) of your computer. This is common with "repack" versions where a virtual emulator is used in place of a physical USB dongle. Common Causes Enable Windows Test Mode Restart the or the

Since the virtual dongle driver is often unsigned, you must allow Windows to run it. Open as an Administrator. Type bcdedit /set testsigning on and press Enter.

Use the 8-digit code from the previous step to generate a new registry ( .reg ) file using your version's specific keygen tool. Right-click GetUID

: The license generated during installation is tied to a specific 8-digit UID; if the registry entries do not match this ID, the software will block access.

To avoid this error in the future, Antivirus software should be temporarily disabled during any re-installation or driver update, as it may flag the emulator as a false positive. Additionally, always run the Autodata shortcut as an to ensure it has the necessary permissions to read the virtual dongle. Autodata 3.45 Installation Guide | PDF - Scribd

: On Windows 10 and 11, the operating system often blocks unsigned virtual dongle drivers unless "Test Mode" is explicitly enabled.