This is the "switching" part of the SMPS (Switched-Mode Power Supply). High-speed chop the DC voltage into a high-frequency square wave. This high frequency allows the use of a much smaller transformer than traditional linear power supplies. 4. The Main Transformer and Secondary Side
The filtered AC is passed through a (often labeled with four diodes) to convert it into a rough DC signal. Most modern HP units like this include Power Factor Correction (PFC) , which uses a boost converter (a large inductor and MOSFET) to ensure the power is drawn efficiently from the wall. 3. The Switching Stage (Primary Side) d10240p1a schematic work
If you are analyzing the schematic for repairs, common failure points in these units include: Circuit Diagrams for Display Supply 32" | PDF - Scribd This is the "switching" part of the SMPS
Unlike standard ATX Power Supplies, the D10240P1A uses a specialized connector layout: 5. Regulation and Feedback Loop
The high-frequency AC enters the , which provides galvanic isolation (safety) and steps the voltage down. On the secondary side, Schottky diodes or synchronous rectifiers convert this back into DC. 5. Regulation and Feedback Loop