Check the connection to your receiver. The receiver must be turned on and the cable must be "live" to power the meter.
If the meter is "maxed out" at 99%, turn the sensitivity down so you can see movement.
Slowly move your dish horizontally (azimuth). Watch the RV3 display: deutsche technologies rv3 digital satellite finder manual
Once connected, follow these steps to lock onto your desired satellite:
Setting up a satellite dish can often feel like trying to find a needle in a haystack—especially when you're out in the wilderness in an RV or setting up a home system. The is designed to take the guesswork out of this process. Check the connection to your receiver
Before you start adjusting your dish, you need to "inline" the finder between your satellite dish (LNB) and your satellite receiver. Turn off your satellite receiver.
Pitch increases as signal strength improves. Powered by Receiver: No external batteries required. 2. How to Connect the RV3 Slowly move your dish horizontally (azimuth)
You may be locked onto the wrong satellite. Many satellites share similar frequencies. Check your receiver to see if it recognizes the specific satellite provider (e.g., Dish, DirecTV, or Free-to-Air).
Once your dish is locked in, disconnect the RV3 and connect the LNB directly to the receiver cable. Leaving the meter inline can cause slight signal loss or "attenuation" during regular viewing.