The hxc-fw-installer.hex file is a crucial firmware component used to install the onto hardware based on STM32 or AT32 microprocessors, most commonly Gotek floppy emulators . This bootloader serves as the foundation for the HxC firmware, allowing vintage computers and industrial equipment to use modern USB sticks instead of aging floppy disks. Purpose and Functionality
Once the bootloader is installed via the .hex file, users gain access to enhanced features: Flash a Gotek with a USB A to USB A cable - HxC2001
Open your programming utility (e.g., Artery ISP Programmer) and select the correct port (often USB DFU ). Hxc-fw-installer.hex
Update procedure. Strap the BOOT0 signal as shown on the above picture. Connect the Gotek to your PC with the USB A USB A cable. ( HxC bootloader installation - HxC2001
Once the .hex file is flashed, the drive is ready to receive the final HxC firmware ( .upd file) via a standard USB stick. Key Benefits of HxC Firmware The hxc-fw-installer
For many drives, you must place a jumper on the BOOT0 pins to put the device into programming mode.
The primary purpose of hxc-fw-installer.hex is to prepare a "blank" or factory-stock Gotek drive for the HxC ecosystem. Once this .hex file is flashed onto the drive's internal memory, it installs a specialized bootloader that enables future firmware updates to be performed simply by using a USB stick, eliminating the need for further hardware-level programming. Prerequisites for Installation Update procedure
To use the hxc-fw-installer.hex file, you typically need the following:
You must often disable flash protection and erase the original factory firmware before adding and flashing the hxc-fw-installer.hex file.
Tools like STM32 Dfuse or the Artery ISP Programmer are required to upload the .hex file from a PC to the drive. Flashing Procedure The installation process generally follows these steps:
you're currently offline