Simrad Rf300 Installation - Manual

Ensure you create a "drip nose" (a loop in the cable where it enters the unit) to prevent water from running down the cable and into the feedback housing or connections. 3. System Calibration & Setup

Install the RF300 on a stable platform near the rudder post. The center of the RF300 should ideally be in line with the center of the rudder post to ensure geometric accuracy. simrad rf300 installation manual

The unit connects directly to the rudder feedback terminals on your Simrad Autopilot Computer (such as the AC12 or AC42). Ensure you create a "drip nose" (a loop

Slowly turn the helm from lock to lock by hand. Verify that the rod does not bind and that there is no mechanical interference throughout the full range of motion. 2. Wiring and Connection The RF300 uses a unique two-wire frequency-based signal . The center of the RF300 should ideally be

Once physically installed, you must configure the autopilot software to recognize the unit. Installation manual