Ts1162 Installation - Manual Exclusive

The TS1162 connects directly to the Challenger system’s LAN.

: Log in to the Challenger Installer Menu (typically Menu + Installer Code + 19) to add and configure the new station.

Once hardware is installed, the RAS must be identified by the Challenger panel. ts1162 installation manual exclusive

The TS1162 is built for longevity, but for high-traffic areas, components like the front label may wear. Genuine replacement labels are available to maintain the professional appearance and legibility of the device. Tecom 3 LED RAS replacement label - GSA Systems

: Features a dedicated Request to Exit (RTE) input and an open collector output for controlling door relays or strikes. The TS1162 connects directly to the Challenger system’s

: Use appropriate screws or bolts for the surface material (e.g., masonry anchors for brick or self-tapping screws for metal). Tighten firmly but avoid over-tightening, which can warp the plastic housing. Step 3: Wiring and Connections

: Connect the D+ , D- , +12V , and 0V terminals to the corresponding terminals on the Challenger LAN bus. The TS1162 is built for longevity, but for

Exclusive Installation Guide for the Tecom TS1162 3-LED RAS Keypad

: Fully protected against dust and immersion in water, making it suitable for wet or outdoor environments.

: Installation should be performed by trained security technicians. If electrical wiring for a power outlet (GPO) is required, you must use a qualified electrician .