Before powering up the unit, ensure your physical installation meets safety standards. Mounting the Controller
Ping the device to see if another piece of hardware is using the same IP. Relay configuration v2000-c user manual
Wire your Wiegand or OSDP readers to the Reader 1 and Reader 2 ports. Before powering up the unit, ensure your physical
Plug a standard Cat5e/Cat6 cable into the RJ45 Ethernet port. 3. Initial Configuration Before powering up the unit
Navigate to the 'Users' tab to enroll card numbers and assign access levels.
Open a browser and enter the IP. Use the default credentials found on the unit's sticker (usually admin / password or similar).