Guide Updated | Xnx Universal Transmitter Quick Start

Only qualified personnel should perform installation and calibration.

Follow the on-screen prompts to "Zero" the sensor in clean air.

Ensure the unit is properly grounded to prevent EMI interference. 3. Powering Up Xnx Universal Transmitter Quick Start Guide

After about 30–60 seconds, the unit will enter normal monitoring mode, displaying the current gas concentration. 4. Navigation and Magnetic Wand

Once wired, apply 24V DC power. The XNX will undergo a self-test routine: The display will cycle through initialization screens. Navigation and Magnetic Wand Once wired, apply 24V

The LED ring will flash (Green for normal, Yellow for fault, Red for alarm).

Never open the enclosure in a hazardous area while the circuit is live. Navigation and Magnetic Wand Once wired

The XNX is designed to work with various sensor technologies, including: For toxic gases and Oxygen. Catalytic Bead: For flammable gases (LEL). Infrared (IR): For combustible gases and CO2.

By following these steps, you can ensure your XNX Universal Transmitter provides reliable gas detection and keeps your workplace safe.